Flip-flow screening is an important method for classifying fine particles. The traditional research of flip-flow screening focuses on the final screening results, and neglects the screen-penetration process. However, the screen-penetration process directly affects the final screening effect. In this paper, a dynamic model of the flip-flow screen-penetration process was proposed and clarified the influence mechanism of main structural parameters on the screening process. First, based on theoretical derivation and regression fitting, the mathematical model of particle screen-penetration rate and screening time was established, and the dynamic evaluation index was obtained. Then, the effect of main structural parameters, namely, the excitation frequency, displacement excitation amplitude, and stretching amount of the screen plate, on the dynamic indexes, was explored. Furthermore, a quadratic polynomial model of the main structural parameters and the two-stage dynamic evaluation index were established by using the response surface method. The explicitness and interactivity of the effects of parameters were elucidated. This work is of great significance for the accurate control of the screening process. 相似文献
This paper presents a case study of an optimized combination of mine water control, treatment, utilization and reinjection to achieve the zero discharge of mine water. Mine water has been considered a hazard and pollution source during underground mining, so most mining enterprises directly discharge mine water to the surface after simple treatment, resulting in a serious waste of water. Moreover, discharging a large amount of mine water can destroy the original groundwater balance and cause serious environmental problems, such as surface subsidence, water resource reduction and contamination, and adverse impacts on biodiversity. The Zhongguan iron mine is in the major groundwater source area of the Hundred Springs of Xingtai, which is an area with a high risk of potential subsidence. To optimize the balance between mining and groundwater resources, a series of engineering measures was adopted by the Zhongguan iron mine to realize mine water control, treatment, utilization, and reinjection. The installation of a closed grout curtain has greatly reduced the water yield of deep stopes in the mine; the effective sealing efficiency reaches 80%. Nanofiltration membrane separation was adopted to treat the highly mineralized mine water; the quality of the produced water meets China’s recommended class II groundwater standard. Low-grade heat energy from the mine water is collected and utilized through a water-source heat pump system. Finally, zero mine water discharge is realized through mine water reinjection. This research provides a beneficial reference for mines with similar geological and hydrogeological conditions to achieve environmentally sustainable mining.
Developing novel oxygen evolution reaction (OER) and hydrogen evolution reaction (HER) catalysts is vital for water splitting. Here, carbon black (CB) and nickel carbonyl powder (NCP) are used as components, and the nonionic surfactant polyvinyl pyrrolidone (PVP) is used as a shape-controlled capping agent to easily prepare layered double (Ni, Fe) hydroxide (NiFe-LDH) electrodes. Scanning electron microscopy observation and X-ray photoelectron spectra analysis show that the Fe2+-doped layered double hydroxide is grown in situ on nickel foam (NF). CB (XC-72) and NCP further improve the electrical conductivity. At 10 mA?cm?2, the overpotentials of the OER and HER are 203 mV and 83 mV, respectively, in 1 M KOH. Only 1.48 V is needed when both electrodes are applied for water splitting, and it has a stability of more than 100 h. This work can be used as a medium to elevate the OER and HER performance of NiFe-LDH-based catalysts. 相似文献
Fluid sloshing usually causes serious safety issues on the dynamic stability and propellant thermal management during the powered-flight phase of launch vehicle. With the wide using of cryogenic propellants, the coupled thermo-mechanical performance during fluid sloshing becomes more prominent. In the present study, one numerical model is established to simulate fluid sloshing by using the VOF method coupled with the mesh motion treatment. The phase change occurring within the tank is considered. Both the experimental validation and mesh sensitivity analysis are made. It shows that present numerical model is acceptable. Based on the developed numerical model, the effect of different super gravity accelerations on fluid sloshing hydrodynamic characteristic is numerically researched. The fluid pressure variation, the sloshing force and sloshing moment, the interface dynamic response and the interface shape variation are investigated, respectively. It shows that the gravity acceleration has caused obvious influences on fluid sloshing characteristic. When the gravity acceleration is higher than 4g0, fluid sloshing becomes more obvious and must be paid enough attention. With some valuable conclusions obtained, the present work is of great significance for in-depth understanding of fluid sloshing mechanism. 相似文献
The isothermal adsorption curves for water vapor on montmorillonite were measured by a gravimetric adsorption system. Dent's model was employed to estimate the adsorption behaviors of water vapor on primary adsorption sites and secondary adsorption sites. The thermodynamics analysis of water vapor adsorption was performed. At low vapor pressure region, primary adsorption predominates, and with increasing vapor pressure, secondary adsorption becomes notable. Primary adsorption sites have an evidently stronger adsorption affinity than secondary adsorption sites. With increasing vapor pressure, Gibbs free energy variation rapidly increases and then reduces slowly. Although increasing vapor pressure raises adsorption spontaneity on primary adsorption sites, the enhancement in vapor pressure decreases the spontaneity of water vapor adsorption on secondary adsorption sites. As adsorbed loading increases, isosteric heat of adsorption and entropy loss decrease first and then increase quickly. The gradually growing water clusters are responsible for the increase of entropy loss at late stage. 相似文献